In the previous video I was unsuccessful in attaching the ceiling panel with the 3M Dual Lock, velcro-type fastener. Today I have a different approach and use the van’s own hydraulic jack with an extension pole, to force the Dual Lock strips together. It is a slow process, where I follow each of the two… Continue reading Van Ceiling Panel – Part IV
Category: Interior
Van Ceiling Panel – Part III
I continue where I left off in the previous article Van Ceiling Panel Part II. As a reminder, I use an automotive tweed protected against daily wear and UV, very similar in color and texture as the front seats of the van. Before I can install the ceiling panel, I still have to finish and… Continue reading Van Ceiling Panel – Part III
Insulate, Cabinet & Wiring
Several smaller jobs this week. I insulate around the side window and permanently install the Tweed Fabric surrounds. Then permanently install the cabinet underneath and pull some wires for a future outlet and some lights. The main job was to connect the gray water valve’s wiring to the 12V circuit and install a ON/OFF switch… Continue reading Insulate, Cabinet & Wiring
Van Ceiling Panel – Part II
I continue where I left off in the previous article Van Ceiling Panel Part I. As a reminder, I use an automotive tweed protected against daily wear and UV, very similar in color and texture as the front seats of the van. In this video, I start by gluing the edges of the fabric to… Continue reading Van Ceiling Panel – Part II
Van Ceiling Panel – Part I
Much of the ceiling has been covered by 1in – 1-1/2in insulation and it’s time to cover it up. I plan to use a 4′ x 8′ (~120cm x ~240cm) sheet of 3/16″ (~5mm) thick plywood covered with an automotive tweed fabric, which I also use on some of the walls and around the windows… Continue reading Van Ceiling Panel – Part I
Window Sill & Cover
Still have a small piece of window, next to the storage closet that needs to be finished. I’ll install a window frame/sill made from Hard Maple and add a plywood cover around it. Later I will use an automotive tweed to finish it. The corners of the frame are made differently than those of the… Continue reading Window Sill & Cover
Webasto Gas Heater – Part 4
I continue the installation of the Webasto Gas Heater by removing the passenger seat and pedestal. The hydraulic car jack that is stored under the seat will be moved to another location. To achieve a good seal between the heater and the floor, I install a separate base plate and seal it with some silicone.… Continue reading Webasto Gas Heater – Part 4
Final Insulation & Closet
In the process of finishing up the passenger side of the interior, I need to insulate the walls. Before I do that, I pulled the last wiring through the wall cavities. The wall insulation consists of rigid Poly-Iso, separated about 0.5 inch from the skin of the vehicle with a few dots of spray foam,… Continue reading Final Insulation & Closet
Storage Boxes & Desk Seat
I fill-in most of the storage boxes in the ‘garage’ of my van. They are all open boxes with inter-locking bottoms, except for the top box, which receives a top lid. This Formica-finished top lid has three functions: as a top lid of course, as an extension of the kitchen countertop and as a worktop… Continue reading Storage Boxes & Desk Seat
Webasto Gas Heater – Part III
After previously installing the fuel pump, I continue with the fuel (and power) line between the pump and the location where the heater penetrates the van floor. For extra security, I use a wireloom around the power wire and use a wider fuel line aorund the tiny Webasto fuel line.