Victron Multiplus 3000 Van Conversion Installation

Multiplus 3000 Up till now I have operated the van without an inverter and several appliances went unused (ic. water heater and induction cooktop). Just being able to use the cooktop will make a major difference while living in the van. (Un)fortunately, the charger part of the Multiplus will only be used infrequently, as I… Continue reading Victron Multiplus 3000 Van Conversion Installation

Victron Smart Devices

The installation of a Victron Smart Solar Controller and a Victron Orion Smart DC-DC Converter as part of my vanconversion. The “Smart” part of this, is the ability to access the settings and output values of these devices through Bluetooth. While the DC-DC Converter is a new addition to the electrical system of the van,… Continue reading Victron Smart Devices

Onboard Compressor – Part 3

In this final episode of the Onboard Compressor installation, I resolve some issues with the Engine Run signal from the Ford Transit. Previously I guided the compressor harness through the engine bay firewall to the area behind the glove box and from there, the wiring is guided behind the center console and under the floor,… Continue reading Onboard Compressor – Part 3

Onboard Compressor – Part 2

In this second part of the Onboard Compressor installation, I show you how I extend some of the wires in the wiring harness of the compressor. The lengthening of the wiring harness is necessary to comply with Ford’s requirements to directly connect the harness to the vehicle battery (through the CCP – Customer Connection Point),… Continue reading Onboard Compressor – Part 2

Induction Cooktop

I continue working to finish the ceiling in small increments; this time above the wardrobe closet. The main focus this week is on the installation of the induction cooktop. The storage for this cooktop is under the kitchen countertop, where I have a tray to store it in and some more storage space under that.