Multi-Use Cabinet (3)

 

advertisement

Fitting the cabinet in the van

3738The RV’s cabinet overhangs the step-in area at the side doors. A simple box with a Cherry front will fill that in. The extension at the top of the will cover the end of the core bottom panel.

 

As we are approaching glue-up, it’s time to check the fitting of the cabinet in the conversion van to reveal any problems or necessary adjustments.

 

35

advertisement

The relative size and location are as expected and with the additional top for the cooktop, it will extend nicely above the bed. One miscalculation I made, was the bump on the step-in panel. A little scribing and removal on the bottom box will solve that.

 

3436

 

Back to the workshop for a full glue-up and the addition of the top.

39

 

494840

Just before glue-up, I used a 7/8” forstner bit to put a hole in the side of the top and bottom panel; a plastic irrigation pipe will be inserted as a way to guide the gas pipe or the electric cord from the cooktop to the bottom of the van.

 

In addition to the pipe, several pieces of ½” blocking is applied to the sides, which adds a lot of rigidness to the cabinet and creates a base for the Cherry plywood finish panels.

 

42

Most plywood connections are simple dadoes or rabbets; a little bit of ordinary wood glue will form a unbreakable link.

 

Cherry frame

By dimensioning (sawing, jointing and planing) some raw Cherry lumber, I create a few 3/8” boards.

434445

The bottom rail is fitted, the curve cut and then glued to the plywood core.

 

47

Bottom rail with its distinct curve.

 

sponsors

Leave a comment

Your email address will not be published. Required fields are marked *