Tag Archives: valance
Cabin Curtain Part 1 – Curtain Track
More dismanteling
I have started preparing the wood for the bed in my workshop, which takes up one half of my garage. I’ll have to glue up thinner boards to get to the right thickness for the wood in the frame of the bed.
In the meantime, I am getting the rear belt systems out. Removing the valance resulted in access to the top connector, which is primarily a big bolt connected to the frame.
The belt roll-up mechanism had to be accessed both from the inside and under the van, which as the only person working on it, posed some problems, but after several attempts, that worked out fine.
This opened up the wheel casing. Time to get rid of the carpet glued to its surface. Careful peeling revealed the casing and reinforcement plate; after removal of the latter, I temporarily taped up the resulting hole from the belt mechanism, until a more permanent solution is applied.
Removal cont. 2
I have two lights that switch on when the rear doors are opened. They have to be removed, but I have plans to reinstall one or both of them at a later time, so I have to be careful not to damage them.
Everything nicely installed with connectors and screws, thus it took me only minutes to take them off.
The remaining 12V wires will be used at a later time.
Next, the valance over the future bed (rear passenger side). Just barely attached with 2 screws. Astonished that it never dropped down. I wonder what would have happened in an accident.
Work done for today! Tomorrow I’ll continue with the safety belts.