Several smaller jobs this week. I insulate around the side window and permanently install the Tweed Fabric surrounds. Then permanently install the cabinet underneath and pull some wires for a future outlet and some lights. The main job was to connect the gray water valve’s wiring to the 12V circuit and install a ON/OFF switch near the driver’s seat.
[videojs_hls url=”https://d3as8i8c4awtvd.cloudfront.net/106e263d-290d-4623-8da5-f9f976001cf6/AppleHLS1/210212+insulate-cabinet-wiring.m3u8″ mp4=”https://d3as8i8c4awtvd.cloudfront.net/106e263d-290d-4623-8da5-f9f976001cf6/FileGroup1/210212+insulate-cabinet-wiring_Mp4_Avc_Aac_16x9_1920x1080p_24Hz_8.5Mbps_qvbr.mp4″ poster=”https://cargovanconversion.com/wp-content/uploads/2021/06/210212-insulate-cabinet-wiring.jpg” width=”1280″ preload=”none”]
TOOLS & MATERIALS*
Denim Insulation
Black Screws & Finish Washers
ON/OFF Switch
Wire Loom
Wire Clamps
Forstner Bits
Woodworking Clamps
14 AWG Wiring
Electrical Tape
Drill
*Some of the links above and in the video, are affiliate links, meaning at no additional cost to you, I will earn a small commission if you click through and make a purchase.
