Monitor Console

Between the window and the side doors is a narrow strip of wall available to house a small console. It is the future location of the battery monitor and a reading light.

010203

With a narrow piece of wood, the length of the console, placed against the inside wall, the curve of the wall is transferred to the wood. Back in the workshop the form is cut and adjusted to get a perfect fit.

04In the meantime, some wood is planed to a 1/2” thickness and the form is temporarily attached to it. With a straight-edge bit, the form is exactly copied to the wood. This and another copy are the two sides of the console.

05The front of the console is a piece of hardboard.

06Three blocks are sandwiched between the two sides, glued and screwed together.

07For a good hold, these blocks will be attached to the metal frame with screws.


 
0809Next the front of the console. This is primarily glued, while further strengthened with a few additional brads.

10Time for some drying.

11The back consists of 3 blocks, equally separated along the back of the console, glued and screwed to the side panels.

12Finally, a soft curve is routed to both corners of the console.

The console will be covered with a fabric material and placed on top of the plywood wall board.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>