Kitchen Cabinet & OBD2 Scanner

Still working to finish the kitchen area by constructing a ceiling cabinet on the side wall behind the wardrobe. It will function as a storage area for plates, bowls, mugs and other items, that I use on a daily basis during food preparation. Kitchen Cabinet One limitation I have, is that the finish material Formica… Continue reading Kitchen Cabinet & OBD2 Scanner

Traction Boards Hardware, Wiring and Countertop

I am working around the kitchen area of the van, to finish the countertop, pull a remaining wire behind the fridge to the battery compartment below it, add some Formica strips to finish the fridge cabinet and to install the traction board hardware. Previously I had temporarily installed the half-finished cover of the induction cooktop,… Continue reading Traction Boards Hardware, Wiring and Countertop

Induction Cooktop

I continue working to finish the ceiling in small increments; this time above the wardrobe closet. The main focus this week is on the installation of the induction cooktop. The storage for this cooktop is under the kitchen countertop, where I have a tray to store it in and some more storage space under that.

DIY Separating Toilet – Part 7

This time, I install the toilet cabinet and connect the drain to the waste water system. Before the toilet cabinet is attached to the floor and side cabinet with screws, a Forstner bit is used to create a large hole, to allow passage of some electrical wires to an electrical outlet and some lights. The… Continue reading DIY Separating Toilet – Part 7